garage door won t open with remote control

The travel limit set in the opener will tell the motor when to stop during the opening or closing of the garage door. The sprocket turns the chain or the belt that holds the door by pulling the trolley. The capacitor jump-starts the motor, which turns the gear and the sprocket. The signal from the wall button goes to the Logic board, which sends the command to the capacitor. When the wall switch button is pressed, it sends a command signal to the door opener to raise or lower the door.

The wall switch should open and close the garage door without the remote control. The video below shows the process of trouble shooting a garage door opener that won’t open with a wall switch. Before taking it apart or replacing ensure you unplug the garage door opener. Follow the laid down guidelines to replace the logic board. Then google the brand model, and just by looking at the pictures, ensure it is the model you have. Replacing the logic boardįor a faulty logic board replacement, first, google the part number printed on the logic board. On the other hand, when the LED light on the wall control didn’t light up, there was a problem with the wall control and follow instructions in step 2 for replacement. For a yellow learn opener, if the wall control LED lit up when you hook up the jumper wire, but nothing happens, the flawed logic board is the issue. If the garage door is still not working, then maybe you have a bad circuit board. Replace the damaged wires using new low voltage wires. If the garage door works, then you have a wiring problem that needs addressing. Using the other end of the jumper wire, connect the wall button to the back of the opener. Make a little jumper wire and attach it to the wall button. If the wiring connection is good, then find some low-voltage wires and wire strippers. When you touch the wires together in step 2, and nothing happens, start by ensuring the wire connections on the back of the garage door is secure. If the garage door opener worked by touching the wires, your wall control is flawed and needs replacement. The opener will operate if the wires and the circuit board are good. There is no danger as the wire is a low voltage circuit. Use a screwdriver to remove the wall button and test the wires by touching them together. If the breaker is not tripped, check to ascertain the outlet is on the same circuit as the GFCI outlet and reset. When there is no power in the garage door opener, check the breaker box. Take a cellphone charger, plug your phone in, and plug it into the outlet to your garage door opener was connected. The following process describes a detailed diagnosis of a garage door that cannot open with a wall switch Step 1. The garage door won’t open with wall switch

If the garage door works, then you have a wiring problem that needs addressing.įor a faulty logic board replacement, google the part number printed on the logic board and the brand model to ensure it is the model you have. Connect the wall button to the back of the opener using the other end of the jumper wire. Find some low-voltage wires and wire strippers. However, if the door doesn’t operate, then test the wires. If the garage door opener performs by connecting the cables, your wall control is flawed and needs replacement. Remove the wall button and push the connecting wires by touching them together.

If the charger works, then test the workability of the wall button. You then unplug the opener from the outlet and plug in a phone charger. Resolving the issues with the garage door that won’t open with a wall switch involves first testing the power outlet connected to the garage door opener. Transferring signal from the wall button to the opener involves the wall button, the wires, and the logic board thus, when the garage door won’t open with the wall switch, check on the power source, wall button, low voltage wires, or the logic board. The malfunction often lies with either the wall switch or your remote control when encountered by a garage door won’t open with wall switch problem.Īlthough solvable, a dead or broken wall switch can cause the garage door not to respond to the command signal. However, like any mechanical product, issues may arise with the wall switch controlling your garage door opener after years of use. The installed hard-wired wall switch opens and closes the garage door without the need for wireless remote control.

Garage door won t open with remote control